Enbio S Autoclave Spares (Magic Filter)

Enbio Magic Filter is a product that will change the work of your autoclave forever. Thanks to its innovative technology based on an ion exchange resin, it enables the reuse of used water in subsequent sterilization processes. Magic Filter follows the idea of “less waste” and also means that you do not have to worry about constantly changing your water bottles. It is a product that respects your time and money while supporting our environment.

Connection with water recycling (Enbio Magic Filter)

Enbio Magic Filter is a filter for recycling water used in the sterilizer. The ion-exchange resin contained

in Enbio Magic Filter allows you to purify wastewater to the level of deionized water in accordance with

the requirements of EN 13060 - that is, water which is recommended and approved for use with Enbio

autoclaves. You only need 1 water tank to use Enbio autoclave with filter.

WATER OUT wastewater connection with Enbio Magic Filter

• Connect the red wastewater hose to the orange wastewater connector that is marked on the rear panel

of the WATER OUT device. The tubing should be inserted into the connector, to the depth of the black

line (placed on the tubing).

• Wastewater should be drained into a water tank. To secure and immobilize the water drain hose from

the unit, use the plug supplied with Enbio Magic Filter and insert the plug into the opening of the water

tank. The unsecured tubing may jump out of the tank and flood the room.

• Make sure that the red tube is never immersed in water, otherwise the water will not drain properly,

causing sterilization errors.

• The water tank must always be located below the unit.

Connection of feedwater WATER IN with Enbio Magic Filter

• Connect the shorter part of the blue Enbio Magic Filter connection hose to the blue water supply

connection, which is marked on the rear panel of the WATER IN device. The tubing should be inserted

into the connector, to the depth of the black line (placed on the tubing).

• Submerge the longer part of the blue Enbio Magic Filter hose into the feed water tank. The unit is

equipped with a water intake pump, so there is no need to place the water tank above or at the same

level as the unit

• To ensure proper operation, Enbio Magic Filter must always be placed in a vertical position

• To prevent the hose from coiling in the water tank, install the included weight with a rubber ring at 2

cm from the end of the hose (fig.)

• To secure and immobilize the water supply hose to the machine, use the plug supplied with the Enbio

Magic Filter and insert the plug into the opening of the water tank. An unsecured tubing may jump out

of the water and cause sterilization errors.

• The minimum water load in the tank is 300 ml.

• Remember and check that the blue tube is always immersed in the water.

• Check the water level in the tank on a regular basis, depending on the frequency of the processes